2016-2023 Tacoma High Clearance Rear Bumper - Yes Cutouts for Parking sensors / Yes add carrier. Rotopax compatible

Spec sheet

Collected from 1 supplier page - confirm fit with the supplier before ordering.

This is the ultimate rear bumper for just about any off road use on your 3rd Gen Tacoma! Whether it be overlanding, rock crawling, or just exploring mountains, desert, and urban jungle this bumper offers added protection, and departure clearance to the truck. The sides add some bedside protection, and offers a sleek but rugged look on your Tacoma. ***Requires cutting off bed side quarters near bottom of tail lights! See installation guide for details. Specs: Made from laser cut and precision brake formed 3/16" HRPO steel, expertly welded and sanded smooth. Beefy 1/4" HRPO Steel mounting plates, bolts up directly to 5 factory locations on each frame mount, same ones the OE receiver hitch used. Standard 3/4" thick through-welded recovery points directly tied to frame mounts. Approximate weight is 140lbs base bumper weight. Carrier adds 70+lbs Standard 2" hitch integrated under the bumper. Standard back up light cutouts for Baja Designs S2 Flush Mount lights. Optional parking sensor cutouts. Blind spot monitoring system is not supported and will need to be removed upon installation. The system can then be turned off via button on Vehicle lower dash. This is not the same system as the Parking Sonar sensors which can be retained if desired. Factory 7-pin trailer connector harness may be too short, can be easily extended with this harness ALL Bumpers Ship Raw/ Bare Steel. A Finish must be applied to prevent rust. Optional Tire carrier info: Carriers come standard with backing plate to mount Rotopax on left side of carrier. Bolt any Rotopax Pack mount directly to our tire carrier backing plate. (You do not need the round Rotopax base plate included with their handles to mount to our backing plate) Optional add on Dual Jerry can holder will fit 2) 5-gallon Jerry cans (Flush weld seam cans only). This Jerry can holder will bolt directly to our Rotopax backing plate so you can switch it up depending on your adventure. Optional camp table is brake formed from 14ga Cold rolled

Suppliers (1)

• Relentless Off-Road Fabrication

  2016-2023 Tacoma High Clearance Rear Bumper - Yes Cutouts for Parking sensors / Yes add carrier. Rotopax compatible · Orderable · stock unverified

  Checked Nov 5, 2026
  $2,548.00
  View at supplier

Specifications and fitment

Parking sensor cutouts

Yes Cutouts for Parking sensors

Add tire carrier?

Yes add carrier. Rotopax compatible

Price history