32 Spline Multi-Pattern Flange

Spec sheet

Collected from 1 supplier page - confirm fit with the supplier before ordering.

32 Spline Multi-Pattern Transfer Case Flange 32 spline output flange with 2" centering pilot and both 2.5" x 2.5" and 3" x 3" bolt threaded bolt patterns. Uses 7/16" NF threaded holes and includes 4 bolts and lock washers. It uses a 2.125" seal surface, if your current output seal is smaller than that you will need to replace your output seal. The great thing about that a wide variety of drive shafts can be made to fit it. With this flange is it possible to use 1310, 1330, 1350, and 1410 series drive shafts with either a single joint or a double cardan (cv), as long as the shafts are built using the correct flange. This will fit a wide range of transfer casesincluding the following. The rear output of any 205 transfer case. The front output of most 205 transfer cases, excluding Chevy versions. The rear output of most 231 transfer cases with a Slip Yoke Eliminator. Atlas transfer cases.

Suppliers (1)

• Tom Wood's Driveshafts

  32 Spline Multi-Pattern Flange · Orderable · stock unverified

  Checked Nov 5, 2026
  $100.00
  View at supplier

Price history