Adams Forged Dana 300, and Dana 20 with 26 Spline 1350 Series Half Round CV Transfer Case Yoke

Spec sheet

Collected from 1 supplier page - confirm fit with the supplier before ordering.

Adams Driveshaft Forged 1350 Series Half Round CV Transfer Case Yoke for a Dana 300, and some Dana 20 Transfer Cases with 26 Spline Outputs. This FORGED Transfer Case Yoke is the STRONGEST on the Market. It will allow you to install a 1350 Series Half Round CV Driveshaft to the Front or Rear of your Dana 300 Transfer Case. It will also fit some older Dana 20s that had 26 spline output shafts. PLEASE MAKE SURE YOU HAVE 26 SPLINES IF BUYING FOR A DANA 20. ONLY SOME MODELS CAME WITH 26 SPLINES, MOST CAME WITH 10 SPLINE. Specs: Spline Count: 26 Spline Diameter: 1.146 Hub Diameter: 1.562 Thru Hole: 1.500 Centerline To End: 3.500 U-joint Series: 1350 This Item will come with the Following Parts: [1] Forged 1350 Series Half Round T-case Yoke. [4] Grade 10 CV Bolts with smaller Heads for easier Installation. [1] Pack of Red Threadlocker. Yoke may come in Silver or Black. CA Residents: WARNING: Cancer and Reproductive Harm – www.P65Warnings.ca.gov Warranty Information LIFETIME WARRANTY AGAINST BREAKAGE TO ORIGINAL PURCHASER.

Suppliers (1)

• Adams Driveshaft

  Adams Forged Dana 300, and Dana 20 with 26 Spline 1350 Series Half Round CV Transfer Case Yoke · Orderable · stock unverified

  Checked Nov 5, 2026
  $109.95
  View at supplier

Price history