4x4 PartsCompare
← Parts database
Front Jeep Drive Shaft, Shackle Reversal - U1

Front Jeep Drive Shaft, Shackle Reversal - U1

Part number
B2U1-131-131
Brand
Tom Wood's
Price range
$469.00
Last checked
Nov 5, 2026

Industry research

4x4 Recovery Gear Compared: Winches, Traction Boards and Supporting Parts

Build a recovery kit around compatible winches, boards, recovery points and rigging, with WARN model references and a practical buying checklist.

Spec sheet

Collected from 1 supplier page - confirm fit with the supplier before ordering.

Driveshaft for Jeep CJ or YJ with Shackle Reversal Jeeps with leaf springs in the front have a shackle at one end of the spring pack. This allows the length of the leaf springs to stretch out and contract as the arch of the spring increases or flattens out. Normally the shackle is at the front of the springs, out toward the front bumper. In this stock configuration as the axle moves down and away from the transfer case it also swings slightly back and towards the transfer case. This results in a counter-action and the length of the drive shaft doesn't change dramatically. Doing a shackle reversal flips things around so instead of having a counter-action you now have a double-action. This usually results in extreme amounts of drive shaft compression and extension, more than normal drive shaft parts can accommodate. This creates a risk of over-compressing the shaft and slamming it into the transfer case or over-extending the shaft to the point that it separates. Either of these scenarios can be catastrophic and can do a lot of damage to the vehicle. This is where our Ultimate Travel drive shaft enters the conversation. This shaft is built using an 11" or longer splined yoke shaft which slides into a splined sleeve in the tube end of the drive shaft. Not every Jeep with a shackle reversal needs this long of a spline though, usually but not always. For us to help you determine what type of shaft you will work best for your Jeep you will need to provide us with a couple measurements. You need to measure the distance from transfer case yoke to pinion yoke as shown in the photo on this page. Measure this at normal ride-height, then again with Jeep lifted by the frame and the axle/springs at full extension. This will give us a good idea about how much extension you need but is not a 100% clear picture. This is because in real life the suspension will move in ways that you can not simulate in your shop or garage. Because of this, we will always want to allow for a little mor

Suppliers (1)

  • Tom Wood's Driveshafts
    Front Jeep Drive Shaft, Shackle Reversal - U1 · Orderable · stock unverified
    Checked Nov 5, 2026
    $469.00
    View at supplier

Specifications and fitment

Spline length
U1

Price history

DateSupplierPriceStock
Nov 5, 2026Tom Wood's Driveshafts$469.00Orderable - stock unverified