SMN500040 Rear Brake Caliper Guide Pin Kit for LR3 LR4 Range Rover

Spec sheet

Collected from 1 supplier page - confirm fit with the supplier before ordering.

The SMN500040 is the rear brake caliper guide pin kit for the Discovery 3 LR3, the Discovery 4 LR4, the Range Rover L322 and the Range Rover Sport L320. It is supplied by Allmakes 4x4 and built to the Land Rover SMN500040 specification. The rear caliper floats on two guide pins, and it only brakes evenly if it can slide freely on them. Once the pins corrode or the rubber boots split, the caliper hangs up. The inner pad then wears faster than the outer, the rear brakes drag, and everything back there runs hot. Replacing the pins and boots puts the caliper back on free movement. This is a cheap part that is well worth doing any time the rear pads come off. A seized guide pin will chew through a fresh set of pads in a few thousand miles, and by then you are paying for the pads twice. FAQ Which Rovers does it fit? The Discovery 3 LR3, the Discovery 4 LR4, the Range Rover L322 and the Range Rover Sport L320. It is a rear brake part, so it does nothing for the front calipers. Is this a Genuine Land Rover part? No. It is an Allmakes 4x4 kit built to the Land Rover SMN500040 specification. Same part number, same job. When should I replace the guide pins? Any time the rear pads come off, and sooner if the pins feel stiff, the boots are torn, or the inner and outer pads are wearing at different rates. Fits: Discovery 3 LR3 L319 (2005 to 2009) Discovery 4 LR4 L319 (2010 to 2016) Range Rover L322 (2006 to 2012) Range Rover Sport L320 (2006 to 2013) Part Number: SMN500040 Free shipping to the lower 48!

Suppliers (1)

• Lucky8 Off Road

  SMN500040 Rear Brake Caliper Guide Pin Kit for LR3 LR4 Range Rover · Orderable · stock unverified

  Checked Nov 5, 2026
  $25.91
  View at supplier

Price history